BWDVL - F-151A MIL-P-24441/2C #26270, F-09P01

  • MSDS: BWDVL
  • Manufacturer: SEAGRAVE COATINGS CORP OF VA
  • Product Name: F-151A MIL-P-24441/2C #26270, F-09P01
  • National Stock Number: 8010-00-410-8458
Product Identification

Product ID:F-151A MIL-P-24441/2C #26270, F-09P01
MSDS Date:09/23/1993
FSC:8010
NIIN:00-410-8458
Kit Part:Y
MSDS Number: BWDVL

Responsible Party
SEAGRAVE COATINGS CORP OF VA
4030 SEAGUARD AVENUE
PORTSMOUTH, VA 23701
US

Emergency Phone: 804-488-4411/800-424-9300 CHERMTREC

Info Phone: 804-488-4411

Cage: 60163

Contractor
SHERWIN-WILLIAMS, SEAGUARD
PORTSMOUTH, VA 23704 US

Telephone: 757-397-2223

Cage: 60163

Ingredients

TITANIUM DIOXIDE

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: 10%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9394


14807-96-6)

CAS: 1480-96-6

Fraction By Weight: 45%


N-BUTYL ALCOHOL (SARA III)

CAS: 71-36-3

RTECS: EO1400000

Fraction By Weight: 30 - 35%

OSHA PEL 100 PPM

ACGIH TLV: S, C 50 PPM; 9394

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


VOC (LB/GAL=3.30) UNITS

RTECS: 9999999VC

Fraction By Weight: 396%

Hazards

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:BREATH OF HI VAP CONCEN MAY PRODUCE
NARCOSIS.LIQ MAY CAUSE MINOR SKIN IRRIT,DEFINITE EYE IRRIT.CAUSES
NOSE/THROAT/EYE/SKIN IRRIT.MAY BE HARMFUL IF ABSORBED THRU
SKIN.REPEAT/PRLONG OVEREXPO TO SOLVENTS COULD CAUSE PERM BRAIN &
NERVOUS SYS DAMAGE.INTENTION MISUSE BY DELIBERATELY CONCEN/INHAL
CONTENTS MAY BE HARMFUL/FATAL
Explanation of Carcinogenicity:PER MSDS:INGREDIENTS NOT KNOWN OR
SUSPECTED CARCINOGEN.
Effects of Overexposure:NARCOSIS. SKIN/EYE IRRIT. NOSE/THROAT IRRIT.
BRAIN & NERVOUS SYS DAMAGE. MISUSE MAY BE HARMFUL OR FATAL.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MFG.

First Aid

First Aid:INHAL:REMOVE TO FRESH AIR. RESTORE BREATH. CONSULT PHYSICIAN.
SKIN:FLUSH W/WATER FOR LEAST 15MINS. REMOVE CONTAMIN
CLOTHING/SHOES. EYE:FLUSH IMMED W/LG AMTS OF WATER FOR LEAST 15MIN.
CONSULT PHYSICIAN . INGEST:GET MED ATTN IMMED.

Fire Fighting

Flash Point Method:SCC
Flash Point:99.0F,37.2C
Lower Limits:1.4
Upper Limits:11.2
Extinguishing Media:WATER FOG, CARBON DIOXIDE, DRY CHEMICAL. OSHA-FLAMM
LIQ CLASS III, DOT-FLAMM LIQ/SOLID
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED GAS MASK FOR FIRE
FIGHTING PERSONNEL. WATER MAY BE USED TO COOL CONTAINERS. IF WATER
IS USED FOG NOZZLES ARE PREFERRED.
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD.VAP MAY MIGRATE
TO IGN SOURCE CAUSE FLASH FIRE.ISOLATE FRM HEAT/SPARKS/ELECT
EQPMT/APPLIANC/PIL LITE/FLAME/IGN SOURCES.FLAMM LIQ/VAP.

Accidental Release

Spill Release Procedures:ABSORB W/ INERT MATERIAL AND DISPOSE OF IN
ACCORDANCE WITH APPLICABLE REGULATIONS OF EPA AND OTHER LOCAL,
STATE AND FEDERAL AUTHORITIES.

Handling

Handling and Storage Precautions:USE W/ADEQUATE VENTILATION.STORE AWAY
FROM HEAT/SPARK/OPEN FLAME.AVOID PROLONG SKIN CONTACT.STORE IN COOL
DRY AREA W/VENTI SUITABLE FOR STORING INGRED
Other Precautions:DO NOT BREATH DUST/VAP/SPARY MIST.WEAR APPROPRIATE
RESP(NIOSH/MSHA APPROVED)DURING/AFT APPLICATION UNLESS AIR
MONITORING RECORDS VAP/MIST LEVELS BELOW APPLICABLE LIMITS.GROUND
CNTRN WHILE POURING.AVOI D SPONT COMBUST OF CONTAMIN RAGS/ORG MAT

Exposure Controls

Respiratory Protection:NIOSH/OSHA APPROVED RESP TYP SUITABLE FOR
INGREDS. APPROVED CHEM/MECH FILTER RECOMMENDED WHEN VENTILATION IS
RESTRICTED. FOLLOW RESP MFG DIRECTIONS FOR USE.
Ventilation:SUFF VENTI IN VOL/PATTERN SHOULD BE PROVIDED TO KEEP AIR
CONTAMIN BELOW CURRENT APPLICABLE OSHA PEL/ACGIH TLV.
Protective Gloves:CHEMICAL RESISTANT PLASTIC OR RUBBER
Eye Protection:CHEM GOGG W/SIDE SHIELDS OR FACE SHIELDS
Other Protective Equipment:AS REQUIRED TO AVOID WETTING CLOTHING.USE
PROT CREAMS WHERE SKIN CONTACT IS LIKELY.EYEBATH AND SAFETY SHOWER.
Work Hygienic Practices:WASH CONTAMIN CLOTHING BEFORE REUSE. DESTROY
SHOES.AVOID CONTACT W/EYES/SKIN/CLOTHING.WASH THOROUGHLY AFTER
HANDLING.
Supplemental Safety and Health
VOLATILE BY WT=29.5%, VOLATILE BY VOL=49.0%, PROD DENSITY:11.2LBS/GAS.
EMPTY CONTAINERS MAY RETAIN HAZARDOUS PROPERTIES AND CAN BE
DANGEROUS. PER TIR:2 PART KIT, THIS MSDS IS FOR UNK PART WHICH MSDS
D OES NOT ID.

Chemical Properties

HCC:F3
Boiling Pt:B.P. Text:243F,117C
Vapor Density:>AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:SOLVENT ODOR, LIQUID.
Percent Volatiles by Volume:SUPPLE

Stability

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING AGENTS.
Stability Condition to Avoid:EXCESSIVE HEAT, SPARKS, OR OPEN FLAME.
Hazardous Decomposition Products:NONE SPECIFIED BY MFG.

Disposal

Waste Disposal Methods:PLACE IN CLOSED CONTAINERS. DISPOSE OF PRODUCT
IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.